 |
RR-5 Hot EF-1 Semi-Permanent Release System
|
|
|
|
|
Home
Composite Releases
Rotational Releases
Rubber Releases
Plastic Releases
Urethane Releases
Specialty Releases
Request a Sample
Other Products
About Us
Privacy Policy
Security Policy
|
DESCRIPTION:
RR-5 is a highly effective, semi-permanent mold release agent. When applied to a clean mold, it forms a smooth, continuous film with good adhesion to the mold surface. This film gives easy release and multiple releases with most rubber and plastic materials. |
|
|
|
BENEFITS:
Multiple releases -- gives increased productivity.
No transfer -- post-finishing problems virtually eliminated.
No knit lines, cracks, or splits -- low scrap rate.
Contains no ozone-depleting chemicals.
|
|
|
|
PROPERTIES:
RR-5 COLD EF-1 is for mold surfaces below 140°F at time of application.
RR-5 HOT EF-1 is for mold surfaces above 200°F at the time of application.
RR-5 HOT EF-1HS gives added lubricity to release film.
RR-5 HOT EF - aerosol formulation is for hot molds. |
|
|
|
APPLICATION PROCEDURES:
Clean, rinse, and dry mold thoroughly. Apply 2 coats of RR-5 by spray, brush, or wipe -- a thin, wet film is best. Use COLD or HOT version based on the mold temperature (see properties above). Let dry completely between coats. Cure RR-5 COLD EF-1 for 10 to 20 minutes at room temperature before putting mold in service. Cure RR-5 HOT EF-1 or RR-5 HOT EF-1HS for 2 to 5 minutes at molding temperature. Reapply RR-5 as needed, allow a few minutes to cure, and continue molding. |
|
|
|
HANDLING:
Both RR-5 COLD EF-1 and RR-5 HOT EF-1 are supplied in solvent solution. Use only with adequate ventilation. Keep away from heat, sparks, or open flame. Avoid prolonged or repeated breathing of vapors. Avoid prolonged or repeated skin contact. Consult MSDS for additional safety information. |
|
|
|
PACKAGING:
RR-5 HOT EF-1, RR-5 HOT EF-1HS, and RR-5 COLD EF-1 are supplied in 1-gallon, 5-gallon, and 55-gallon containers. RR-5 HOT EF is supplied in 12 oz. aerosol cans. |
|
|
|
|
|
Releasomers® is a trademark of Stoner Inc. All contents © Stoner, Inc. 2012. All rights reserved. |
|