FRP 1923 WB is a room temperature curing, water-based semi-permanent release agent for the FRP and composite industries. Applied to a clean mold, it forms a smooth, durable, glossy film with good adhesion to the mold surface. FRP 1923 WB gives easy, multiple releases.

A trademark of Stoner Inc.

1070 Robert Fulton Hwy.

Quarryville, PA 17566

800-227-5538 • 800-515-5150 (fax)

Home

Releasomers Benefits:

•  Multiple Releases
•  Increased Productivity
•  No Transfer
•  Reduced Scrap
•  No Finishing Problems
•  No Knit Lines or Cracks

	FRP 1923 WB Semi-Permanent Release for Reinforced Plastics


	DESCRIPTION: FRP 1923 WB is a room temperature curing, water-based, semi-permanent release agent for the FRP and composite industries. Applied to a clean mold, it forms a smooth, durable, glossy film with good adhesion to the mold surface. FRP 1923 WB gives easy, multiple releases.

	BENEFITS: Water-based Environmentally and user friendly Multiple cycles Increased productivity Ambient cure Wipe on leave application

	APPLICATION PROCEDURES:

	New Molds: Clean, rinse and dry mold surface. Wipe on one coat, making sure to leave a thin, even, wet coat on the surface. Wipe on a second coat within 1-2 hours. There is no need to polish the mold after application -- simply wipe on FRP 1923 WB and allow to dry. If the second coat is applied after 2 hours, it may become necessary to polish the mold using a soft, cotton cloth if the surface has become difficult to wet. Seasoned Molds: Clean, rinse and dry mold surface. Wipe on one coat making sure to leave a thin, even, wet coat on the surface. Curing: Allow molds to air dry 30 minutes before use. Longer dry time may increase the number of releases. Reapply as needed

	HANDLING: FRP 1923 WB should be stored at temperatures below 90°F. Protect from freezing

	PACKAGING: FRP 1923 WB is available in 5-gallon and 55-gallon containers.

	All contents © Stoner, Inc. 2008. All rights reserved.

FRP 1923 WB Semi-Permanent Release for Reinforced Plastics