 |
RR-5 HOT WB Semi-Permanent
Release System
|
|
|
|
|
Home
Composite Releases
Rotational Releases
Rubber Releases
Plastic Releases
Urethane Releases
Specialty Releases
Request a Sample
Other Products
About Us
Privacy Policy
Security Policy
|
DESCRIPTION:
RR-5 HOT WB is a silicone resin emulsion, semi-permanent release. RR-5 HOT WB gives outstanding results in very tough release applications. Applied to a clean mold, it forms a smooth, continuous film with good adhesion to the mold surface. |
|
|
|
BENEFITS:
Multiple releases -- gives increased productivity.
No transfer -- post-finishing problems virtually eliminated.
No knit lines, cracks, or splits -- low scrap rate.
Very low build-up -- more production time between mold cleanings.
No VOC's or ODC's present -- carrier is water only.
|
|
|
|
PROPERTIES:
RR-5 HOT WB is for application to mold surfaces above 212°F at the time of application. |
|
|
|
APPLICATION PROCEDURES:
RR-5 HOT WB can be applied by spray, brush, or wipe -- best method is a fine mist spray. Clean, rinse, and dry mold thoroughly. Reinstall in press and heat above 212°F. Apply two or three light coats of RR-5 HOT WB about one minute apart with a fine mist applicator. Let it bake a short time at mold temperature -- one minute minimum (5 to 10 would maximize the number of releases). Repeat as needed, using one light coat. |
|
|
|
HANDLING:
RR-5 HOT WB should be stored at temperatures below 90°F. Protect from freezing. |
|
|
|
PACKAGING:
RR-5 HOT WB is available in 1 gallon, 5 gallon and 55 gallon containers. |
|
|
|
| Releasomers® is a trademark of Stoner Inc. All contents © Stoner, Inc. 2012. All rights reserved. |
|