 |
|
| A trademark of Stoner Inc. |
| 1070 Robert Fulton Hwy. |
| Quarryville, PA 17566 |
| 800-227-5538 • 800-515-5150 (fax) |
| releasomers@stonersolutions.com |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Releasomers Benefits: |
|
• Multiple Releases
• Increased Productivity
• No Transfer
• Reduced Scrap
• No Finishing Problems
• No Knit Lines or Cracks |
|
|
Release Coat 33
Bake On Release System
|
|
|
|
|
|
|
|
|
DESCRIPTION:
Release Coat 33 is a highly effective, semi-permanent mold release agent. When applied to a clean mold, it forms a smooth, continuous film with good adhesion to the mold surface. This film is highly abrasion resistant and gives easy and long lasting release. Release Coat 33 performs very well in rotational molding as well as PVC interior car parts. |
|
|
|
|
|
BENEFITS:
Multiple releases -- gives increased productivity.
No transfer -- post-finishing problems virtually eliminated.
No knit lines, cracks, or splits -- low scrap rate.
Temperature capabilities up to 575°F.
Molds stay clean -- reduces downtime costs.
|
|
|
|
|
|
APPLICATION PROCEDURES:
Release Coat 33 can be applied by spray, brush or wipe. Clean, rinse, and dry mold thoroughly. Apply one or two coats of Release Coat 33 -- a thin, wet film is fine. Let dry for five minutes between coats. Cure coating a minimum of 15 minutes at 300°F or higher. One hour would maximize the durability of the Release Coat 33. Reapply one coat as needed, cure at mold temperature per above, and continue molding. |
|
|
|
|
|
HANDLING:
Release Coat 33 is supplied in a flammable solvent solution. Use only with adequate ventilation. Keep away from heat, sparks, or open flame. Avoid prolonged or repeated breathing of vapors. Avoid prolonged or repeated skin contact. Keep closed when not in use. Consult MSDS for additional safety information. |
|
|
|
|
|
PACKAGING:
Release Coat 33 is supplied in 1-gallon, 5-gallon, and 55-gallon containers. |
|
|
|
|
|
All contents © Stoner, Inc. 2008. All rights reserved.
|
|
|
|